How to Adjust Bolt Cutters


Not sure how to adjust bolt cutters? You’ve come to the right place for we’re about to explain the method from start to finish.

First off, find a stable worktable. Then, gather the required materials for the process. According to, you should prepare a pair of gloves, a piece of paper, and a crescent wrench.

After wearing the gloves, proceed to the following steps:

  1. Look for the hexagonal eccentricity bolt (for tension adjustment) which is typically the middle one near the intersection of the handles.
  2. On your worktable, place the bolt cutter on its side to let the eccentricity bolt face upward.
  3. Loosen the eccentricity bolt by rotating a crescent wrench over it counterclockwise.
  4. Put a paper between the two halves of the bolt cutter which are loosened by the wrench.
  5. Tighten the bolt once again in a clockwise direction until it presses the paper.

If you’re unsatisfied with the results while testing the bolt cutter, simply repeat the steps.

Also, just in case you encounter dirty bolts, spray a grease cleaner on them. This can enhance the accuracy and efficiency of the process. Still, you might need to add grease later on if ever the bolts would be too hard to control.

After getting the right adjustment, don’t stop there. The blades should be super-sharp as well. Check out some tips on how to sharpen bolt cutters.

In Conclusion

You should know¬†how to adjust bolt cutters so you can cut almost anything – no matter how thick it is. The adjustment¬†focuses on the tension, so make sure you know where is the eccentricity bolt. Most of the time, it is located in the middle of the handles’ intersection.

In case of emergencies, learn how to cut a padlock with bolt cutters.

Looking for more tools to add to your collection? Find out what’s the best adjustable wrench set for various bolts.